Becky's Stampin' Studio: Unbounded Beauty Puzzle Slider Card

This is one of Sue Campfield's original ideas for her Puzzle Slider Card. It utilizes the Unbounded Beauty DSP and Unbounded Love Bundle. I added my own twist with a few Glimmer paper accents. So pretty and so easy to do!

Measurements:

Basic White: 4 1/4" x 9 1/2", 2 pcs @ 2 1/8" x 2 1/4", 2 pcs @ 2 1/8" x 3 1/4", scrap
Unbounded Beauty (N): 3 3/4" x 5" (Berry Burst print)(front), 4" x 5 1/4" (stripe)
Berry Burst Glimmer Paper (OE): scraps

To Make This Card:

Score card base at 1" - 2" - 7 1/2" - 8 1/2" (or 1" & 2" from each end) Accordion fold each end well. Set aside.
Take DSP for the front, and cut as follows. The idea is to keep the pattern matched AFTER you cut it apart, hence the "puzzle" aspect of this card.
First, cut the DSP piece in half lengthwise at 1 7/8". Take the TOP strip and cut a 3" piece, which leaves 2". Lay that out as it was, on the table.
Take the BOTTOM strip and reverse the measurements. Cut a 2" strip FIRST, which leaves a 3" piece. Lay this out with the other 2 pieces, which will reassemble the whole piece
Next, lay out the White layering pieces. These ARE all rectangles, so make sure you have the smaller pieces laid out correctly. You can double check them with the DSP pieces. They only fit one way.
Adhere the DSP pieces to the corresponding White layer. I took mine one at a time and placed them back in place on my table.
Let's finish the inside next. Add the Berry Burst Stripe to the inside. Stamp sentiment in Berry Burst ink onto piece of White and die cut with scallop oval die from the Unbounded Love Dies. Attach to inside of card.
Now, back to the front of the "base". Add Tear n Tape to the top 1" on each side.
Starting with the upper left "puzzle piece", add to 1" piece, matching upper corner, top and sides of the flap.
Repeat with the lower left "puzzle piece", and then go to the other side and finish. The pieces might overlap slightly, that is not a problem!
For the outside "labels", Stamp sentiment onto scrap of White. Die cut with label die, as shown. Also, cut same die from Berry Burst Glimmer paper. Cut in half and mount behind label.
Also die cut detailed "leaves" from scraps of Berry Burst Glimmer paper.
Add single leaf to inside, tucked under oval.
Attach double leaves to back of labels. and attach all to the front panel, as shown, with Mini Dimensionals.
Finish with Rhinestones colored with Berry Burst Blend, and a bow of retired Berry Burst ribbon.