Becky's Stampin' Studio: Valentine Kissing Booth

Wednesday, January 28, 2026

Valentine Kissing Booth

I found this cute sample by Debbie Henderson using the darling Valentine Kisses bundle in the Online Exclusives! It also uses the Made with Love DSP from the Jan-Apr Mini Catalog. The little hearts are from the Loose Valentine Assortment, too clever! We also made this sample at my Senior Center class.

Measurements:

Real Red: 1/2 sheet
Basic White: 2 pcs @ 4" x 5 1/4", scraps
Bubble Bath: 2" x 2 1/2" (booth), scrap
Pecan Pie: 2 3/4" square
Made with Love DSP (N): 3 7/8" x 5 1/8", 1/2" x 5 1/8" strip

To Make This Card:

Begin by taking the DSP piece and cut it at 2 5/8" making 2 pieces.
Adhere to one White layer. The larger, dotty piece at the top and the hearts at the bottom. There is only a 1/16" border.
Before adhering to the Real Red card base, run tape runner over strip of ribbon and adhere over where the 2 pieces of cardstock meet, wrapping the ends to the back.
Now, you can attach this piece to the folded Real Red card base.
Next, die cut the "kissing booth" from Bubble Bath cardstock. Place glue dots on the right side of the "supports" and then adhere to the "booth base".
Attach Dimensionals to the "booth" and adhere to card base about 1" from the right side, with "counter top" just below the ribbon.
Next, stamp large "bear" and "booth bear" in Early Espresso ink onto Pecan Pie cardstock. Cut out with corresponding dies.
Place "booth bear", flat inside the booth, and attach the "bear" near "booth", as shown, with Dimensionals.
Complete the card with the little "bouquet" stamped in Real Red ink onto Bubble Bath cardstock, little "plaque" in White with Real Red stamped hearts, and sentiment stamped in Real Red ink on strip of White.
Finish with 3 White hearts from the Loose Valentine Assortment.
Finish inside with White layer and strip of DSP.