Here is another Flip Flap Fold original! I used a previous card (actually an Explosion Card) and made it into a different fold!! Why reinvent the wheel, right! I LOVE placing my little penguin on a "Wobble" for a little "action"!
Measurements:
- Fresh Freesia: FULL sheet
- Basic White: 2 3/4" x 4", scraps
- Penguin Playmates SAB (ret): 3 pcs @ 4" x 5 1/4". 2 - "snowflakes", 1 Fresh Freesia print
To Make This Card
- Take full sheet of cardstock and fold in half, crease well. Open up and fold in half the other way, crease well. (Or, score at 4 1/4" and turn and then 5 1/2".) Use Paper Trimmer and trim away lower left quarter.
- Now refold, as shown. (This version has a different orientation! But it works!)
- Attach Freesia print DSP to front around outside edges. Cut Scallop Contour Rectangle from the front. (Watch the orientation!!) Remove DSP center and keep this to use later.
- Cut this same Scallop Contour Rectangle from piece of Basic White. Then, run it throught the "Snowflake" Wintry 3D mini Embossing Folder.
- Open up front flap. Attach one "snowflake" DSP piece. Close front and insert Embossed White piece through the opening, attaching to opposite side.
- Stamp penguin as shown. Punch out with coordination punch!
- You will need to stamp and "fussy cut" the "hat" and "scarf".
- I added this little guy to the White label with a "Wobble". (which you can get on Amazon and some stamp stores).
- Now, open the card up all the way. Place the last "snowflake" piece on the left, and the removed print scalloped rectangle through the opening.
- I added a trimmed message on top of the label, and pearlized snowflakes on the other side.
- Finish with a Fresh Freesia Open Weave Ribbon bow.
- Note: I didn't leave anywhere to add a message. So, I would probably remove one snowflake and add a small piece of white or Fresh Freesia to the left side to write on!
