I didn't originally get this DSP as the colors are rather non-tradtional holiday colors. But I LOVE them!! I actually don't mind Blushing Bride trees!! And the Hologram accents...gorgeous! So here is another simple card using the stunning DSP and dies! Once again, the picture doesn't do this justice!
Measurements:
- Blushing Bride: 1/2 sheet
- Basic White: 4" x 5 1/4", 2 3/8" x 5 3/8", 2 3/4" x 4" (label), scraps (tree/sentiment)
- Whimsy & Wonder DSP (N): 2 1/8" x 5 1/8" (snowflake), 1 1/2" x 5 1/8" (stripe)
To Make This Card:
- Fold Blushing Bride card in half. Cut away 1 3/4" from front of card. Toss this piece.
- Attach quarter sheet of White to the inside of card. Add Stripe DSP to right side.
- Attach White piece to front flap. Then, add Snowflake DSP.
- Cut scalloped rectangle from Scalloped Contour Dies.
- Cut large, detailed tree from Blushing Bride cardstock. Attach, flat, to rectangle at far left.
- Stamp smaller tree in Blushing Bride on a scrap of white. Attach over pink tree with Dimensionals.
- Stamp "joy" in Blushing Bride. Fussy cut around the word. Lay a strip of Blushing Bride ribbon as shown. Attach sentiment with Dimensional.
- Now, attach half of rectangle to front flap.
- Finish with Rhinestones as shown.
- As an added note, I also cut 2 "small tall trees" from scraps of the pearlized snowflake paper and added them to the inside!! Don't forget to use these awesome scraps!
No comments:
Post a Comment