Becky's Stampin' Studio: Welcome Noel Mounted Double Gate Fold

This gorgeous card was designed by Mary Deatherage. It's just beautiful, as is this entire Neutral Noel Suite! For this idea, she used the Neutral Noel DSP and Metal Effects Specialty Paper, along with those darling Welcome Noel "houses" and greenery from the Noel Tidings bundle. Lots of pieces, but definitely worth the effort!

Measurements:

Mossy Meadow: 4 1/4" x 5 1/2", scrap
Basic Beige 2-Tone Cardstock: 4 1/8" x 5 1/2" (base)
Basic Beige: 2" x 3 1/4" (arch)
Basic White: 3 7/8" x 4" (inside layer), 1/4 sheet
Metal Effects Specialty Paper (N): 2 pcs @ 1" x 4 1/8", 15 "berries"
Neutral Noel DSP (N): 4 pcs @ 1 7/8" x 4" (brocade)

To Make This Card:

Emboss the 2 Metal Effects Specialty Paper strips with the Softly Woven 3D Embossing Folder.
Adhere these to the left & right of the Mossy Meadow "postcard" base, leaving a small edge showing.
Score the Basic Beige 2-Tone base @ 2" and 4" from each end. Fold the 2 outside score lines as "mountain" folds, and the 2 inner score lines as "valley" fold.
Adhere the 4 DSP pieces to these 4 gate panels.
On the White inside layer, stamp sentiment in Pecan Pie ink, and the pine bough in stamped off Mossy Meadow ink. Adhere to inside of card "base".
Now, for all the die cutting!
First, cut the 3rd from the smallest arch from the Everyday Arches in Basic Beige. Run through the Softly Woven 3D Embossing Folder. Set aside.
Also, die cut one "wreath" from Mossy Meadow cardstock. Add to larger house!
Next, stamp the following: in Pecan Pie ink - Large House, 3 "berry sprigs", Sentiment. In Crumb Cake ink - Small House. In Mossy Meadow ink: 3 "pine boughs"; Large Pine Tree. Die cut all of these from corresponding dies.
Also, die cut approx 15 "berries" from the Metal Effects Specialty Paper scraps.
First, adhere the "berries" to the "sprigs". Set aside to dry.
Now, to arrange all the pieces! This all gets placed on the Basic Beige Arch.
Begin with the Large Pine Tree. Adhere near the upper left corner with Liquid Glue.
Next, add one "berry sprig" and one "pine sprig" over the tree. (See close up).
Now, add one "berry sprig" and one "Pine sprig" to the right of the "tree". (I rearranged the "berries" as needed. Why hide them!
Next, add the large house with Dimensionals, and the smaller house over and to the left, also with Dimensionals. Then, tuck the remaining "sprigs" under smaller house, trimming as necessary.
Finish with sentiment.
Now, take the arch and adhere the LEFT side only to the front, left "gate".
Finish front with small Gold Dot to the wreath, and 3 Gold Dots to the inside.