Becky's Stampin' Studio: Double Vision Sunset Coast

Tuesday, May 19, 2026

Double Vision Sunset Coast

I just love this new, Double Vision technique! It is particularly stunning with a scenic DSP, just over the top with our new Scenic Coast Specialty DSP (check out the iridescence). I'm also always on the lookout for unique dies, and the dies in the Sunset Coast Bundle are just that - unique! This sample, I went back to the lower Dimensional "edges" for the popped up pieces. I DO think I like that effect the best! You need to give this technique a try!

Measurements:

Blueberry Bushel: 1/2 sheet, 4" x 5 1/4" (mounting piece); 3 1/4" x 4"
Basic White: 4" x 5 1/4", scrap
Scenic Coast DSP (N): 1 - 6"x 6" sheet

To Make This Card:

Look at your "scenic" DSP piece and decide which area you might want to use, first. Note: you could die cut the "focal point" layer first, and use it to check it out. And, then trim this piece to 4" x 5 1/4".
Take this DSP piece and cut it into 8 - 1/2" strips. Make sure as you cut you keep them in order!
Begin with the farthest LEFT piece and adhere it directly to the Blueberry Bushel "mounting" piece. I would suggest using Multipurpose Glue for these pieces, too.
Then, LAY the next into place, for spacing, and adhere the next, third, piece.
Continue with "placeholder" and adhered piece until 4 pieces are on your card base.
Now, for the OTHER 4 pieces. These will be popped up! I used the outside edges of my Dimensional sheet.
Before you line these up and pop them into place, put Multipurpose Glue on top of the adhesive of the Dimensionals to help you slide them into place without them grabbing so fast! Isn't that neat!
I started from the LEFT, again, lined up the pattern, and adhered them into place!
Sit back and admire the effect!
Now, you can adhere this piece to the folded Blueberry Bushel card base.
Next, I die cut the "sailboat" die near to top of the "focal point" layer. Emboss the sentiment in White below this opening. Or, if you prefer, you can emboss first, and then die cut the image.
I added this to the front of the card.
Now, die cut the 3 "seagulls" in White. Add them wherever you think you need them.
Finish the inside with a 1/2" strip cut from the leftovers of your DSP. I also stamped a sentiment and the 2 little "sailboats" in Blueberry Bushel ink.
I didn't add any additional embellishments, the paper is just so gorgeous!