These 2 cards use the same technique...adhering the Die Cut Wave to the Waves of the Ocean DSP and cutting around it, then mounting to your card! The first one is a copy of one shown on the Flyer. The other one is a "Becky Original" and uses a Glossy White "wave" and pops it on top of a panel of stamped Gentle Waves.
FLYER SAMPLE
Measurements:
- Mint Macaron: 1/2 sheet
- Waves of the Ocean DSP (N): 4" x 5 1/4" (Saffron & Pink), 2 5/8" strip (Cabana)
- Blue Foils (N): 2 5/8" strip (Coastal Cabana)
- Adhesive Sheet: 2 5/8" x 12"
- Basic White: scraps
To Make This Card:
- Attach DSP to folded Mint Macaron card.
- Adhere Adhesive Sheet to back of Coastal Cabana Foil piece.
- Die cut out "wave" of your choice. Remove backing from "wave" and attach to Cabana DSP. Note: I like to place it in one corner, so I only have to cut around 1 side!
- Cut around Foil. Note: If you look closely at the sample on the Wave Promotion Flyer, they did not cut right up to the foil, but left about 1/4" all the way around.
- Attach "wave" to card front with Dimensionals.
- Cut 2 large "clouds" and one small "cloud" from White cardstock. Attach to card as shown. The large "clouds" are attached with Dimensionals.
- Cut "seagulls" from Coastal Cabana scraps. Peel back from "seagulls" and add to card.
- Finish with Coastal Cabana "Wave" Jewels.
MY SAMPLE
Measurements:
- Night of Navy: 1/2 sheet
- Waves of the Ocean DSP (N): 2 5/8" strip (Darker Blues)
- Glossy White (ret): 2 5/8" strip
- Adhesive Sheet: 2 5/8" x 12"
- Basic White: 1/4 sheet, scraps
To Make This Card:
- Place Gentle Waves background stamp onto Stamparatus acrylic plate. Ink up with Pacific Point ink and stamp onto White quarter sheet. Reink and restamp if necessary!
- Trim this piece to 4" x 5 1/4". Note: I left this piece larger, to begin with, so I had room for the magnets to hold it to the platform.
- Attach this stamped and trimmed piece to folded Navy card.
- Adhere Adhesive Sheet to back of Glossy White piece. I like the sheen of the Glossy for the "wave"! Unfortunately, it is retired. Hopefully, you have it in your "stash".
- Die cut out "wave" of your choice. Remove backing from "wave" and attach to Blues DSP. Note: I like to place it in one corner, so I only have to cut around 1 side!
- Cut around Glossy cardstock.
- Attach "wave" to card front with Dimensionals.
- Stamp sentiment inn Night of Navy onto scrap of White and cut out with narrow tag die, from the Waves Dies.
- Run narrow Night of Navy ribbon through tag openings. I tied a knot at either end. Attach to card with Dimensionals.
- Finish with scattered Rhinestones.
Glossy White 8-1/2X11 Card Stock
[102599]
$5.95
No comments:
Post a Comment