Becky's Stampin' Studio: Detail Heart Corner Angle Fold Card

Thursday, April 22, 2021

Detail Heart Corner Angle Fold Card

After I made the Blushing Bride Heart Card, I grabbed a few remaining die cuts and Specialty Papers that were around me and designed this card! This also uses the Many Hearts Dies, the Love You Always Specialty Paper and Foil Paper, and the new Pearlescent Paper. Also added a Die Cut from the Always Dies.

Measurements:

Sahara Sand: 1/2 Sheet
Very Vanilla: 2 pcs - 4" x 5 1/4" (1 is template)
Love You Always Specialty DSP (N):3 3/4" x 5", 2 3/4" square
Pearlescent Paper (N): 4" x 5 1/4", 3 3/4" square, 2 3/4" square, scrap
Love You Always Foil (N) - scrap

To Make This Card: (see video)

Begin by making the corner "template". Take one of the Very Vanilla pieces. Measure along the short side 2 3/4" and place a mark. Then, measure along the long side to 3 1/2" and make a mark. Draw a line with a pencil, connecting the 2 marks. Cut along this line. Save the triangle, and discard the rest of the piece. Use it for another card.
Fold card base in half. Place "template" along upper left corner of card. Score along "pencil" line with Bone Folder. It should lightly transfer to the back side. Flip card front over and repeat for the back side. Now, carefully fold along score lines, inverting the corner to the inside of card.
Take one of the other Very Vanilla pieces, and lay inside the card, leaving an 1/8" border. Mark the score line and trim this piece. Trim approx 1/8" from the cut edge. Check for fit. Take the small corner you removed, and fit to the upper triangle.
To layer the outside. Repeat with the Pearlescent piece. Using the scored/folded edge as a guide to cut your layer, and then repeating with the DSP layer. Always allowing for an 1/8" border!!
To decorate the front, cut large heart from "scalloped heart" die and Pearlized Paper. Add a layer of DSP cut from the Specialty DSP, and a "detail heart" cut from the Pearlescent Paper. Add to front of card.
Cut "Love" from scrap of Pearlescent Paper, as well as a "shadow" from Sahara Sand Foil. Adhere to front of card.
To decorate the inside, attach the Very Vanilla corner, then layer the Specialty DSP cut from the front layer.
Finish with a Very Vanilla bow.
Some will also place DSP on the upper, inside flap of card. Your choice!!