I saw this card design that I had never seen before and decided to try it! Loved using the gorgeous, new Hand Penned Bundle to create it! I also hope to try it cut lengthwise.
Measurements:
- Highland Heather: 1/2 sheet
- Basic White: 4" x 5 1/4", scrap
- Hand Penned DSP (N): 4" x 5 1/4"
To Make This Card:
- Fold Highland Heather card in half. Find the center of the card and place a mark. Now, cut from the "tick mark" to the upper fold. Repeat for other side. Keep cut pieces.
- Repeat with the DSP. Adhere the large triangle to the "front flap". It fits perfectly as is. Attach to card with top edge flush.
- Take the 2 trimmed triangle DSP pieces. Trim an additional 1/8" from long sides. Either use the same side or flip and use the other side! Adhere to triangles.
- Now, we will attach the "triangles" to the card. These may either be attached to show on the front, or like mine, hidden in the back. To do this, you take the same piece was trimmed and reposition it so that one point touches the bottom, one point touches the side, and the other touches the crease, as shown. Hit those points and it will lay flat. Close down the front flap, mark where the flap meets the "triangle" and place adhesive from these marks to the point and adhere to flap. Repeat with other side.
- Stamp the "bouquet" in Basic Gray on scrap of White. Color with Blends as shown and cut out with coordinating die. Attach to card front with Dimensionals.
- Finish with Highland Heather bow and Resin Dots flower centers.
Absolutely beautiful but sounds so complicated to do. I’ve got to give it a try though. I’ll have to read this a few times before it sinks in. Thank for the instructions. 🥰
ReplyDelete